![]() ![]() Click Search Segment to search for devices in a specified network segment.Click the edit button to modify device information. If the status icon is grayed out, place your mouse cursor over the icon to view the cause of the error. means the camera gets online successfully. Click Custom Add, and enter the IP address and other required information.Right-click on the preview page, and click Menu > Camera > Camera.NOTE!Īfter the device is added, if the wrong username or password message shows in the preview window, click in the window toolbar and enter the correct username and password. Select the devices to add in the discovered device list, and then click Add. Use a power supply that meets requirements.Ĭonnect the device to power and turn on the power switch (if applicable).Ĭlick > Shutdown on the screen toolbar in live view page.ĭo not disconnect power when the NVR is operating or shutting down.īefore you begin, make sure the devices are connected to your NVR via network.įollow the wizard to the fourth step. Make sure the cables are connected correctly and the device is grounded properly. Repeat the steps to install all the disks. Align the disk with the slot and slide the disk inward gently until it clicks.For front panel with screws, loosen the screws on the front panel.For front panel with buttons, press the buttons on both sides of the front panel.With the disk interface side down, install the R (for right) and L (for left) bracket according to the figure below. Fix the mounting brackets to the disk with screws.Fasten the brackets installed with hard disks to the device.Put the cover back in place, and secure it and the mounting plates with screws.Repeat the steps to connect all the disks. Connect the power cables and data cables as shown in the figure. Fix the screws according to the figure below. Secure the disks on the mounting plate.Repeat the steps to remove the lower mounting plate (for 8-HDD devices only). Turn the upper mounting plate in the shown direction, then remove the plate.Loosen the screws of the mounting plate on the side panels.Choose the installation method according to your device model. The installation steps for devices with mounting plate and disk bracket are different. Slide the upper cover backward, then lift it up to remove the cover.Put the cover back in place and tighten the screws.Ĥ or 8 HDD Installation Remove Upper Cover.Connect the power cables and data cables.Slide the disk into place from A to B, and fix the screws to secure the hard disk.Insert the screws into the disk and tighten the screws halfway.Loosen the screws on the rear panel and side panel and remove the upper cover.Prepare a 1# or 2# Philips screwdriver, a pair of antistatic gloves or a wrist strap.The illustrations are for reference only. ![]() The following part shows the interfaces of two typical models. Uniview UNV-3 Series Network Video Recorders Indicators LED uniview UNV-3 Series Network Video Recorders User Guide. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |